E

Time/temperature curve for epoxy full cure.

Two-part epoxy systems for long-life markings.

Sensor monitoring exhaust heat upstream of the DPF. Data is used by the ECU to control automatic regeneration cycles.

Replacement silencer pack reducing auxiliary-engine noise output. Helps fleets meet strict local night-time sound limits.

Special nozzle fitted at the end of a spray bar to achieve a sharp defined edge. Reduces waste and overspray on adjacent lanes.

Screed/Extruder‑applied hot thermoplastic producing raised profile lines.

Solenoid valve isolating the final nozzle pair during half-lane spraying. Prevents overlap stripes and material wastage.

Electric/gas heaters that keep thermoplastic shoes at working temperature.

Ejector plate empties hopper without high tip.

An emergency stop reset procedure defines the steps required to safely return equipment to service after an emergency stop has been activated. It ensures that hazards are addressed before systems are re-energised. The procedure typically involves identifying the cause of the stop, confirming the area is safe, and following a prescribed reset sequence. Skipping steps…